Install Server Hardware Options; Remove The Security Bezel - Lenovo ThinkSystem SR860 Setup Manual

• Remove the device from the package and install it directly into the server without putting it down. If it is
necessary to put the device down, put it back into the static-protective package. Never place the device
on the server or on any metal surface.
• When handling a device, carefully hold it by the edges or the frame.
• Do not touch solder joints, pins, or exposed circuitry.
• Keep the device from others' reach to prevent possible damages.

Install server hardware options

This section includes instructions for performing initial installation of optional hardware. Each component
installation procedure references any tasks that need to be performed to gain access to the component
being replaced.
Installation procedures are presented in the optimum sequence to minimize work.
Attention: To ensure the components you install work correctly without problems, read the following
precautions carefully.
• Make sure the components you are installing are supported by the server. For a list of supported optional
components for the server, see http://www.lenovo.com/serverproven/.
• Always download and apply the latest firmware. This will help ensure that any known issues are
addressed, and that your server is ready to work with optimal performance. Go to ThinkSystem SR860
Drivers and Software to download firmware updates for your server.
• It is good practice to make sure that the server is working correctly before you install an optional
component.
• Follow the installation procedures in this section and use appropriate tools. Incorrectly installed
components can cause system failure from damaged pins, damaged connectors, loose cabling, or loose
components.

Remove the security bezel

Use this procedure to remove the security bezel.
Before removing the security bezel:
1. Read the safety information and installation guidelines (see "Safety" on page iii and "Installation
Guidelines" on page 58).
2. If the server is installed in a rack, extend or remove the server from the rack.
To remove the security bezel, complete the following steps:
Step 1. Use the key to unlock the security bezel to the open position.
60
ThinkSystem SR860 Setup Guide