Device In The Multi-Drive Conversion Kit - Lenovo ThinkStation p910 Hardware Maintenance Manual

6. Slide the plastic bracket with the new 2.5-inch storage drive into the front-access storage enclosure
until it snaps into position. Press the notch to secure the enclosure cover and lock the enclosure
cover with the key.
Figure 33. Installing the bracket with the 2.5-inch storage drive into the front-access storage enclosure
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 213.

Device in the Multi-drive Conversion Kit

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
The Multi-drive Conversion Kit (hereafter referred to as kit) might be equipped with either one or both
of the following components:
• Slim optical drive
• Internal storage drive (such as hard disk drive, solid-state drive, or hybrid drive)
Slim optical drive
To install or replace a slim optical drive in the kit, do the following:
Note: The instructions on how to install or replace a slim optical drive in the kit also apply to the Slim
Optical Drive Adapter.
1. Slide the kit out of the chassis. See "Device in an optical-drive bay" on page 107.
2. If you are replacing an old slim optical drive, do the following:
116
P910 Hardware Maintenance Manual