Lenovo ThinkStation p910 Hardware Maintenance Manual page 146

8. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the flex
module cover engage the rails on the flex module. Then, push the cover to the front of the flex module
until it snaps into position.
Figure 78. Reinstalling the flex module cover
9. Install the flex module into the flex bay.
10. Connect the card reader cable to the 29-in-1 card reader connector on the system board. See "Parts on
the system board" on page 35.
11. Reconnect any removed cables to the flex module.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 213.
eSATA connector or IEEE 1394 connector
To install or replace an eSATA connector or IEEE 1394 connector in the flex module, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 101.
2. Do either of the following:
• Disconnect the eSATA connector cable from the eSATA connector on the system board.
• Disconnect the IEEE 1394 cable from the IEEE 1394 adapter.
3. Remove the flex module out of the chassis. See "Device in an optical-drive bay" on page 107.
140
P910 Hardware Maintenance Manual