Card Reader - Lenovo ThinkStation p910 Hardware Maintenance Manual

6. Slide the new slim optical drive with the plastic clip into the flex module until the slim optical drive
snaps into position.
Figure 71. Installing the slim optical drive in the flex module
7. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the flex
module cover engage the rails on the flex module. Then, push the cover to the front of the flex module
until it snaps into position.
Figure 72. Reinstalling the flex module cover
8. Install the flex module into the flex bay. Reconnect any removed cables to the flex module.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 213.

Card reader

To install or replace a card reader in the flex module, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 101.
2. Disconnect the card reader cable from the 29-in-1 card reader connector on the system board. See
"Parts on the system board" on page 35.
3. Remove the flex module out of the chassis. See "Device in an optical-drive bay" on page 107.
.
Chapter 9 Installing or replacing hardware
137