Lenovo ThinkStation p910 Hardware Maintenance Manual page 159

6. Install the bracket with the new storage drive into the hard-disk-drive bay. See step 6 on page 151.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 213.
Installing or replacing a 2.5-inch storage drive with a converter in a hard-disk-drive bay
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To install or replace a 2.5-inch storage drive with a 2.5-inch to 3.5-inch converter in a hard-disk-drive
bay, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 101.
2. Locate the hard-disk-drive bay in which you want to install or replace a storage drive. See "Internal
drives" on page 37.
3. Remove the storage drive bracket from the hard-disk-drive bay. See step 3 on page 148.
4. Depending on whether you are installing or replacing a storage drive, do one of the following:
• If you are installing a storage drive, pivot tab
as shown until the four tabs on the adapter are slide into the four notches
shown to remove it from the converter.
Figure 97. Removing the adapter from the converter
• If you are replacing a storage drive, do the following:
a. Remove the converter from the bracket. See step 4 on page 148.
1 on the metal adapter upward. Then, push the adapter
1
2
2 . Pivot the adapter as
.
Chapter 9 Installing or replacing hardware
153