Lenovo ThinkStation p910 Hardware Maintenance Manual page 127

6. Pivot the rear cover of the kit inward until you hear a click. The rear cover is secured in place.
Figure 43. Pivoting the rear cover inward
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 213.
2.5-inch internal storage drive
To install or replace a 2.5-inch internal storage drive in the kit, do the following:
1. Slide the kit out of the chassis. See "Device in an optical-drive bay" on page 107.
2. Press the clip as shown to open the rear cover of the kit.
Figure 44. Opening the kit from the rear
3. If you are replacing an old 2.5-inch internal storage drive, do the following:
.
Chapter 9 Installing or replacing hardware
121