Lenovo ThinkStation p910 Hardware Maintenance Manual page 177

5. Align the notch 1 on the new flex adapter with the slot key
plastic retainer of the new flex adapter downward into the corresponding slot in the multi-function
bracket. Then, insert the adapter into the flex adapter slot until it is secured tightly.
Notes:
• Do not touch the circuit board of the flex adapter.
• Ensure that you install the flex adapter only into a flex adapter slot. Do not install the flex adapter
into a PCI or PCI Express card slot.
Figure 123. Installing the flex adapter
1
6. Pivot the tab downward until it snaps into position. Ensure that the latch inside the multi-function
bracket is closed.
Figure 124. Closing the card latch
7. If a device only works with its cable connected to the flex adapter, connect the cable to the new flex
adapter.
2 in a flex adapter slot. Then, slide the
1
2
Chapter 9
1
.
Installing or replacing hardware
171