Lenovo ThinkStation p910 Hardware Maintenance Manual page 79

This section provides information about the following topics:
• "Entering the Intel RSTe configuration utility" on page 73
• "Creating RAID volumes using the Intel RSTe configuration utility" on page 73
• "Deleting RAID volumes using the Intel RSTe configuration utility" on page 74
• "Resetting hard disk drives to non-RAID" on page 74
Entering the Intel RSTe configuration utility
This section provides instructions on how to enter the Intel RSTe configuration utility.
During the computer startup, follow the instructions on the screen. Press Ctrl+I to enter the Intel RSTe
configuration utility.
The following four options are displayed after you enter the Intel RSTe configuration utility:
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non ‐ RAID
4. Exit
Press the up and down arrow keys to select an option. Press Enter to enter the menu for the selected
option. Press Esc to exit the Intel RSTe configuration utility, or select Exit, and then press Enter to exit the
Intel RSTe configuration utility.
Creating RAID volumes using the Intel RSTe configuration utility
This section provides instructions on how to use the Intel RSTe configuration utility to create RAID volumes.
To create a RAID volume, do the following:
1. Enter the Intel RSTe configuration utility. See "Entering the Intel RSTe configuration utility" on page 73.
2. Press the up and down arrow keys to select Create RAID Volume, and then press Enter to view the
CREATE VOLUME MENU window.
3. The following five options are displayed. Press the up and down arrow keys to select an option. After
you configure an option, press Tab or Enter to go to the next option.
a. Name: Volume name. You can use the default name or type a preferred name.
b. RAID Level: You can change the RAID Level to one of the following:
• RAID Level 0
• RAID Level 1
• RAID Level 10
• RAID Level 5
c. Disks: Press Enter to enter the SELECT DISKS MENU window. Follow the instructions at the bottom
of the menu to select hard disk drives, and then press Enter to complete the configuration.
d. Strip Size: Press the up and down arrow keys to select a strip size.
e. Capacity: Customize the capacity of the RAID volume. The default RAID volume is the largest value.
4. Press Enter to finish configuring all the five options. When prompted, press Y to confirm the creation of
the new RAID volume.
5. After the new RAID volume is created, the information about the RAID volume will be displayed under
DISK/VOLUME INFORMATION, such as ID number, name, RAID level, strip size, volume size, status,
and whether it is a bootable volume.
.
Chapter 6 Advanced configuration
73