Spark Plug; Hub Oil Check - PIAGGIO Beverly 300 i.e. Service Station Manual

Beverly 300 i.e.

Spark plug

Proceed as follows:
- Remove the case that grants access to the spark
plug located on the right side fairing by unscrewing
the indicated screw.
- Disconnect cap «A» from the spark plug HV ca-
ble by turning it clockwise until releasing it from the
retainer.
- Unscrew the spark plug using the wrench sup-
plied.
- When refitting, place the spark plug into the hole
at the corresponding angle and finger tighten it as
far as it will go. Use the wrench only to tighten it.
- Place cap «A» fully over the spark plug, making
sure it is in the retainer again.
WARNING
SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS
COLD. REPLACE THE SPARK PLUG AS INDICATED IN
THE SCHEDULED MAINTENANCE TABLE. THE USE OF
ELECTRONIC CENTRAL UNITS AND OF NON-COMPLIANT
ELECTRONIC IGNITIONS OR SPARK PLUGS OTHER
THAN THOSE PRESCRIBED MAY SERIOUSLY DAMAGE
THE ENGINE.
N.B.
USE OF SPARK PLUGS OTHER THAN THE INDICATED
TYPE OR UNSHIELDED SPARK PLUG CAPS CAN LEAD
TO FAULTS IN THE VEHICLE 'S ELECTRICAL SYSTEM.
Hub oil
Check
-Place the vehicle on the centre stand on flat
ground;
- Remove the oil dipstick «A», dry it with a clean
cloth and put it back into its hole tightening it
completely;
Remove the dipstick and check that the oil level is
slightly over the second notch starting from the
lower end; if the level is under the MAX. mark, it
needs to be filled with the right amount of hub oil.
Maintenance
MAIN - 41