Rear Brake Pads Refitting; Fill - Rear Combined - PIAGGIO Beverly 300 i.e. Service Station Manual

Beverly 300 i.e.
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
- Screw the two pad lock pins to the correct torque,
and apply the recommended product.
- Fit the calliper on its support, tightening the two
screws to the prescribed torque.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY POSITION THE
CALLIPER ON THE DISC DURING FITTING, GENTLY EX-
PAND THE PADS.
Recommended products
Loctite 243 Medium-strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Screw tightening calliper to support
fastening pin
19.6 to 24.5
Fill
Rear - combined
- Remove the rubber cap from the bleed screw.
- Insert a rubber pipe in the bleed screw to permit
the brake fluid to be recovered.
- With the brake lever, load the system and bring
it up to the required pressure.
- Keeping the brake lever pulled, loosen the bleed
screw to purge the air in the system. Then tighten
the bleed screw
- Repeat the operation until only brake fluid comes out of the rubber pipe.
- Remove the fluid recovery pipe and refit the rubber cap over the bleed screw.
- Top up the brake fluid to the right level in the reservoir.
If necessary, bleeding can be done using a special vacuum pump
N.B.
DURING THE BLEEDING OPERATIONS, MAKE SURE THE BRAKE FLUID DOES NOT COME INTO
CONTACT WITH THE BODYWORK SO AS NOT TO DAMAGE IT. FURTHERMORE, DURING THE
BLEEDING OPERATIONS REGARDING THE BRAKE CALLIPERS, MAKE SURE THE BRAKE
FLUID DOES NOT COME INTO CONTACT WITH THE DISC BRAKES AND WITH THE BRAKE
PADS. FAILURE TO OBSERVE THIS PRECAUTION WILL ENDANGER THE PROPER WORKING
AND EFFICIENCY OF THE BRAKING SYSTEM
Specific tooling
Pad
24 to 27
Braking system
BRAK SYS - 241