Top-Up - PIAGGIO Beverly 300 i.e. Service Station Manual

Maintenance

Top-up

For topping-up, proceed as follows:
- Remove the mirrors unscrewing them from their
seats
- Unscrew the two screws «A» and remove the
pressure covering.
- Unscrew the two screws «B» and, working on
both sides of the vehicle, unscrew the screw «C».
- Using a flat-headed screwdriver, detach the fas-
tener tab as shown in the figure, accessing the tab
via the indicated slit.
- Insert the screwdriver between the two covers,
as indicated in the figure, and detach the upper
fastener tab. Move the rear handlebar cover aside.
- Unscrew the two screws «D» and remove the
front handlebar cover releasing the front headlight
connector
- Unscrew the two screws «E» and remove the cap
«F» of the brake pump to top up to the optimum
level.
WARNING
BRAKING CIRCUIT FLUID IS HIGHLY CORROSIVE; MAKE
SURE THAT IT DOES NOT COME INTO CONTACT WITH
THE PAINTWORK.
CAUTION
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID.
WARNING
THE BRAKE FLUID IS HAZARDOUS: IN CASE OF ACCI-
DENTAL CONTACT, WASH OFF WITH WATER.
WARNING
THE BRAKING CIRCUIT LIQUID IS HYGROSCOPIC, AND
ABSORBS THE HUMIDITY OF SURROUNDING AIR. IF THE
HUMIDITY IN THE BRAKING FLUID EXCEEDS A CERTAIN
VALUE, IT WILL LEAD TO INEFFICIENT BRAKING. NEVER
USE BRAKING FLUID KEPT IN CONTAINERS THAT HAVE
ALREADY BEEN OPENED, OR PARTIALLY USED.
Recommended products
Brake fluid Brake fluid
FMVSS DOT 4 Synthetic fluid
MAIN - 48
Beverly 300 i.e.