Spark Plug Dismantlement - PIAGGIO X7 EVO 300ie Manual

TYRES
Front tyre
Rear tyre
Tubeless, 120/70-14'' 55P
Tubeless, 140/60 - 13'' 63P

Spark plug dismantlement (03_10, 03_11)

Proceed as follows:
Remove the access cover over the spark plug on the right-hand side of the scooter,
reach the spark plug and slide it off with your hand;
- Disconnect cap «A» from the spark plug HV cable by turning it clockwise until re-
leasing it from the retainer.
- Unscrew the spark plug using the wrench supplied.
- When refitting, place the spark plug into the hole at the corresponding angle and
03_10
finger tighten it as far as it will go. Use the wrench only to tighten it.
- Place cap «A» fully over the spark plug, making sure it is in the retainer again.
N.B.
USE OF SPARK PLUGS OTHER THAN THE INDICATED TYPE OR UNSHIELDED
SPARK PLUG CAPS CAN LEAD TO FAULTS IN THE VEHICLE 'S ELECTRICAL
SYSTEM.
WARNING
03_11
THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. CHECK
THE SPARK PLUG AS INDICATED IN THE SCHEDULED MAINTENANCE TABLE.
USING NON-COMPLYING ELECTRONIC CENTRAL UNITS AND ELECTRONIC
IGNITIONS OR SPARK PLUGS OTHER THAN THOSE PRESCRIBED MAY SERI-
OUSLY DAMAGE THE ENGINE. IF THE SPARK PLUG IS REMOVED AFTER A
45