Diagnostic Code - 1 Flash - PIAGGIO Beverly 300 i.e. Service Station Manual

Beverly 300 i.e.
ted but with a limitation imposed on the number of
revs.
2. Previously unused control unit - transpond-
er absent or cannot be used: The LED is per-
manently ON; in this condition, no operations are
possible, not even starting the vehicle.
3. Programmed control unit - service key in-
serted (normal conditions of use): a single 0.7
second flash is displayed, after which the LED re-
mains off permanently. The engine can be started.
4. Programmed control unit - Master key inser-
ted: a 0.7-sec flash is displayed followed by the
LED remaining off for 2 sec and then by short 0.46-
sec flashes, the same number of times as there
are keys stored in the memory including the Mas-
ter key. When the diagnosis has been completed,
the LED remains permanently OFF. The engine
can be started.
5. Programmed control unit - fault detected: a light code is displayed according to the fault detected,
after which the LED remains on permanently. The engine cannot be started. The codes that can be
transmitted are:
- 1-flash code
- 2-flash code
- 3-flash code

Diagnostic code - 1 flash

A one-flash code indicates a system where the se-
rial line is not present or is not detected. Check the
Immobilizer aerial wiring and change it if necessa-
ry.
Electrical system
ELE SYS - 79