Spark Plug Dismantlement - PIAGGIO BEVERLY Cruiser 500ie Manual

Spark plug dismantlement (03_08)

This engine has two spark plugs. To remove them, proceed as follows:
1. Remove the access cover over the spark plugs on the left-hand side of the scooter
and reach into the spark plugs with your hand;
2. Disconnect the caps «A» of the spark plug HV wire;
3. Unscrew the spark plugs using the spark plug wrench supplied;
4. When refitting, place the spark plugs into the hole at the required angle and tighten
by hand until it is finger tight;
03_08
5. Use the wrench only for final tightening of the spark plug;
6. Place caps «A» fully over the spark plugs
CAUTION
SPARK PLUGS MUST BE REMOVED WHEN THE ENGINE IS COLD. SPARK
PLUGS MAINTENANCE OPERATIONS ARE DESCRIBED IN THE SCHEDULED
MAINTENANCE TABLE. USING NON-CONFORMING ELECTRONIC CENTRAL
UNITS AND ELECTRONIC IGNITIONS OR SPARK PLUGS OTHER THAN THOSE
PRESCRIBED MAY SERIOUSLY DAMAGE THE ENGINE.
N.B.
THE USE OF SPARK PLUGS OTHER THAN THE INDICATED TYPE OR OF
SHIELDLESS SPARK PLUG CAPS CAN CAUSE ELECTRICAL SYSTEM FAIL-
URES.
Characteristic
Spark plug
NGK CR7EKB
Electrode gap
42