Spark Plug Dismantlement - PIAGGIO Fly 125 ie Manual

TYRE PRESSURE
Front tyre pressure
Rear tyre pressure
Rear wheel pressure (rider and
passenger):
1.8 bar
2 bar
2.3 bar

Spark plug dismantlement (03_10, 03_11)

In order to inspect the spark plug, follow the operation described when the engine is
cold:
1. Remove the access door «A» after unscrewing the corresponding screws;
2. Detach the spark plug cap;
3. Remove the spark plug with the spanner supplied (with fixing rubber).
To refit, repeat the procedure in reverse order using the spanner to insert the spark
plug or to tighten it in its seat. Care should be taken to installing and fixing it with correct
03_10
inclination
To refit the door follow the steps in reverse order, making sure to insert the tabs in
their slots.
WARNING
THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. THE USE
OF A SPARK PLUG WITH THERMAL GRADE OR THREAD OTHER THAN THE
INDICATED TYPE (SEE «DATA» SECTION) CAN SERIOUSLY DAMAGE THE EN-
GINE. REPLACE SPARK PLUGS AT THE INTERVALS INDICATED IN THE
03_11
SCHEDULED MAINTENANCE TABLE.
39