Spark Plug Dismantlement - PIAGGIO MP3 125 i.e. HYBRID Manual

Spark plug dismantlement (03_07, 03_08)

Proceed as follows:
1.Remove the access cover over the spark plug on the right-hand side of the scooter,
reach the spark plug and slide it off with your hand;
2.Disconnect spark plug HV wire cap «A»;
3. Unscrew the spark plug using the wrench supplied;
4.Upon refitting, place the spark plug into the hole at the required angle and tighten it
by hand.
03_07
5.Use the wrench only to tighten it;
6.Push cap «A » fully over the spark plug.
N.B.
USING SPARK PLUGS OTHER THAN THE INDICATED TYPE OR SHIELDLESS
SPARK PLUG CAPS CAN CAUSE ELECTRICAL SYSTEM FAILURES.
WARNING
03_08
THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. CHECK
THE SPARK PLUG AS INDICATED IN THE SCHEDULED MAINTENANCE TABLE.
USING NON-COMPLYING ELECTRONIC CENTRAL UNITS AND ELECTRONIC
IGNITIONS OR SPARK PLUGS OTHER THAN THOSE PRESCRIBED MAY SERI-
OUSLY DAMAGE THE ENGINE. IF THE SPARK PLUG IS REMOVED AFTER A
FLOODED ENGINE (EXCESSIVE FUEL EXPULSION IN THE «SAFE RIDING»
SECTION), KEEP THE TUBE CONNECTED TO THE SPARK PLUG AND THE
LATTER IN CONTACT WITH A GROUND POINT FAR FROM THE SPARK PLUG
HOLE ITSELF IN ORDER TO AVOID THE EXPELLED FUEL FROM CATCHING
FIRE.
Characteristic
Spark plug
65