TYRE INFLATION PRESSURE
Front tyres pressure
Rear tyre pressure (with
passenger)
2 bar
2.4 (2.6) bar
Spark plug dismantlement (03_10, 03_11)
This engine has two spark plugs.
Remove the port on the left-hand side panel of the vehicle by undoing the fixing screw
«A» and using a small screwdriver in the rear notch, then proceed as follows:
1.Disconnect the caps «B» of the HV cables of the spark plugs
2.Undo the spark plugs with the specific spark plug spanner.
3.When refitting, place the spark plugs into the hole at the required angle and tighten
by hand until it is finger tight;
03_10
4.Use the wrench only to tighten it;
5.Insert the caps «B» on the spark plugs all the way to the bottom;
6.Refit the flap ensuring that the rear fastener is engaged.
CAUTION
SPARK PLUGS MUST BE REMOVED WHEN THE ENGINE IS COLD. SPARK
PLUGS MAINTENANCE OPERATIONS ARE DESCRIBED IN THE SCHEDULED
03_11
MAINTENANCE TABLE. USING NON-CONFORMING ELECTRONIC CENTRAL
UNITS AND ELECTRONIC IGNITIONS OR SPARK PLUGS OTHER THAN THOSE
PRESCRIBED MAY SERIOUSLY DAMAGE THE ENGINE.
76