Cylinder Head - PIAGGIO Beverly 300 i.e. Service Station Manual

Characteristics
If a crankshaft comprising two half-shafts of different categories needs to be replaced, also replace both
crankcase halves, combining the two components (Shaft and Crankcase) featuring the same category.

Cylinder Head

Before performing head service operations, thoroughly clean all coupling surfaces. Note the position of
the springs and the valves so as not to change the original position during refitting
- Using a trued bar and a feeler gauge check that
the cylinder head surface is not worn or distorted.
Characteristic
Maximum allowable run-out:
0.1 mm
- In case of faults, replace the head.
- Check the sealing surfaces for the intake and exhaust manifold.
- Check that the camshaft and the rocking lever pin capacities exhibit no wear.
- Check that the head cover surface is not worn.
- Check that the coolant seal plug exhibits no oxidation.
- Insert the valves into the cylinder head.
- Alternatively check the intake and exhaust
valves.
- The test is carried out by filling the manifold with
petrol and checking that the head does not ooze
through the valves when these are just pressed
with the fingers.
CHAR - 20
Beverly 300 i.e.