Figure 1: Installing Or Removing The Instrument Into Or From The Rack - Tektronix ECO8000 Series User Manual

Figure 1: Installing or removing the instrument into or from the rack

ECO8000 Series Automatic Changeover Unit User Manual
To remove the instrument from an equipment rack. Perform the following steps to
remove an instrument that is installed in an equipment rack:
WARNING.
To prevent injury when removing the product from the rack, do not
forcefully and abruptly pull the product from the rack. Pull with the minimum
force required to move the instrument with a consistent, even motion.
1. Loosen the knob screws, if present, that attach the front of the instrument
to the rack.
2. Gently pull the instrument toward you until you can reach the levers at the
rear of the instrument.
3. Tilt both lever handles upward simultaneously to allow them to clear the
stops. (See Figure 1.)
4. Pull the instrument past the stops and out of the rack.
Getting Started
5