Table of Contents
Advertisement
Remote control
How to use the Web Interface
ECO8000 Series Automatic Changeover Unit User Manual
This section describes how to use the ECO8000 Series Web Interface and how
to use SNMP traps for remote control.
You can remotely control the ECO8000 Series using the Web Interface. When
the Web Interface is enabled in the SYSTEM CONFIG menu, you can use a Web
browser to remotely access the instrument. When you enter the IP address of
the instrument in a supported Web browser, the ECO8000 Web Interface opens
as shown in the following figure. Click the various tabs to access the instrument
settings and controls as you would using the front panel buttons. (See Figure 34.)
NOTE.
The Web Interface must be enabled from the SYSTEM CONFIG menu on
the instrument front-panel before it can be accessed from a Web browser. (See
page 65, SYSTEM CONFIG menu.)
All of the settings and functions that can configured using the front panel are
available in the Web Interface except for the following:
Configuring the SNMP settings
Configuring the network settings
Configuring the Web Interface level of control setting
Performing a firmware upgrade
NOTE.
Just like making setting changes using the instrument front panel, making
setting changes using the Web Interface which affect the basic operation of the
instrument are only possible when the instrument is in MANUAL mode. When the
instrument is in AUTO mode, the Web Interface is selectively locked out and is
therefore safe to use for status monitoring.
95
Advertisement
Table of Contents
