Table of Contents
Advertisement
Menus
88
ENABLED. Displays whether or not a software option is installed. NONE is
displayed for no software option is installed. LTC is displayed if Option LTC is
installed.
KEY. Displays the current option key string in the form
XXXXX-XXXXX-XXXXX-XXXXX-XXXXX-X, with each X
representing an alphanumeric character. To edit the option string, perform the
following steps:
CAUTION.
Do not edit this string unless you are upgrading to Option LTC.
Before you edit the string, verify that you are upgrading the correct instrument.
The upgrade documentation will list the MAC address of the instrument to be
upgraded. Use the NETWORK CONFIG submenu to view the MAC address.
(See page 72.)
NOTE.
It is easier to use the Web Interface to enter the option key string since
you can enter the string directly or cut and paste the string into the entry box. If
you cut and paste the string, be careful not to include any extra spaces at the
ends of the string.
1. Press the ENTER button to enter the option key edit mode. The underscore
character (_) appears under the first character of the option key.
2. Use the up (▲) or down (▼) arrow button to select the first character of
the option key.
3. Use the left (◄) or right (►) arrow button to move the underscore character
to the next character in the option key.
4. Enter all of the option key characters, and then press ENTER button to
confirm the selection.
5. Press the BACK button to exit the OPTIONS submenu.
ECO8000 Series Automatic Changeover Unit User Manual
Advertisement
Table of Contents
