Network Installation; Figure 2: Location Of Rear Panel Power Connectors (Eco8000 Shown) - Tektronix ECO8000 Series User Manual

Network installation

ECO8000 Series Automatic Changeover Unit User Manual
Connect the power cable(s). Standard instruments are shipped with one Power
Supply module installed in slot 1. If you ordered Option DPW, your instrument
was shipped with two Power Supply modules installed.
Connect the power cable(s) to the instrument first, and then connect it to the AC
power source. Connecting the power cable causes the instrument to power on.
After connecting the power, make sure that the fan in the instrument is working.
If the fan is not working, turn off the power by disconnecting the power cable
from the AC power source, and then contact your local Tektronix Field Office
or representative.
A power-on self test is run when the instrument first boots up. (See page 27,
Power-on self test.)

Figure 2: Location of rear panel power connectors (ECO8000 shown)

Configure the preferred supply (Option DPW only). If your instrument has two
Power Supply modules installed, configure one of the supplies to be the preferred
(active) supply. (See page 37, Configuring the preferred (active) supply (Option
DPW only).)
The ECO8000 Series has a 10/100 BASE-T Ethernet port on the rear panel that
allows you to use a PC to remotely control the instrument.
This section provides instructions for connecting the ECO8000 Series to a single
PC or to a network and for setting the network parameters on the Ethernet port.
Getting Started
7