Tektronix ECO8000 Series User Manual page 31

Automatic changeover unit
Hide thumbs Also See for ECO8000 Series:
Table of Contents

Advertisement

ECO8000 Series Automatic Changeover Unit User Manual
6. The second line of the display will show an IP address after the instrument
receives an address from the DHCP server. The message "Waiting for DHCP"
will appear until the instrument receives the address.
7. After the display shows an IP address, press the BACK button to exit the
NETWORK CONFIG submenu.
To configure parameters for a network without a DHCP server. If your network
does not have a DHCP server, perform the following procedure to set the network
parameters:
1. Press the front-panel BACK button as necessary to access the top-level Main
menu.
2. Press the up (▲) or down (▼) arrow button to select SYSTEM CONFIG,
and then press the ENTER button to access the SYSTEM CONFIG menu.
3. Press the up (▲) or down (▼) arrow button to select NETWORK CONFIG,
and then press the ENTER button to access the NETWORK CONFIG
submenu. The display shows whether DHCP is enabled or not.
4. If necessary, press the left (◄) or right (►) arrow button to select Disable,
and then press the ENTER button to implement the selection.
5. If you connected the instrument directly to a single PC:
a. Press the up (▲) or down (▼) arrow button to select IP ADDRESS, and
then press the ENTER button to enter the edit mode.
b. Use the arrow buttons to set the IP address to be the same IP address as
the PC's address except for the last number, and then press the ENTER
button. The last number in the address must be different than the last
number in the PC's IP address.
c. Press the up (▲) or down (▼) arrow button to select SUBNET MASK,
and then press the ENTER button to enter the edit mode.
d. Use the arrow buttons to set the subnet mask to be the same net mask
(subnet mask) used by the PC, and then press the ENTER button. Do not
enter a number if the PC does not have a net mask.
e. You do not need to enter a GATEWAY address if you are directly
connected to a single PC.
f.
Press the BACK button to exit the NETWORK CONFIG submenu.
Getting Started
9

Advertisement

Table of Contents
loading

Table of Contents