Mitsubishi Electric FR-A5AP Instruction Manual page 17

ORIENTATION CONTROL—A500(L)
<Inverter I/O terminals>
Symbol
X22 Orientation command input
(*1) terminal
SD Common terminal
ORA
In-position signal output terminal
(*2)
ORM Orientation fault signal output
(*2) terminal
Open collector output common
SE
terminal
*1 Assign the function of the X22 signal to any of the input terminals using "input terminal function selection" (Pr.180 to
186).
Refer to the inverter manual for details of input terminal function selection.
*2 Assign the functions of the ORA/ORM signal to any of the output terminals using "output terminal function
selection" (Pr.190 to 195).
Refer to the inverter manual for details of output terminal function selection.
Terminal
Used to enter an orientation signal.
Common terminal for the orientation signal.
Switched low if the orientation has stopped within the in-position
zone while the start and orientation signals are input.
Open collector output. (Permissible load 24VDC, 0.1A)
Switched low if the orientation has not stopped within the
in-position zone while the start and orientation signals are input.
Open collector output. (Permissible load 24VDC, 0.1A)
Common terminal for the ORA and ORM open collector output
terminals. Isolated from the common terminal of the control circuit.
Description
10