Device Management
After settings are successfully finished, the page is shown in the figure below.
Step 2: Set Router 2 that acts as a client.
❶
PPTP/L2TP Client: Click Enable.
❷
Type: Click PPTP client.
❸
WAN: Select an enabled WAN port of Router 2 (VPN client) (In this example, WAN0).
❹
Server IP/Domain Name: Enter an enabled WAN port IP address of the VPN server.
❺
Username/Password: Enter a username/password assigned to the client by the server.
❻
Encryption: Click Enable to enable encryption.
❼
Remote LAN: Enter a server LAN.
❽
Remote subnet mask: Enter a subnet mask of server LAN.
❾
Click OK.
- 66 -