Device Management
Set rule contents.
❶
IPSec: Click Enable.
❷
WAN: Select an enabled WAN port of this tunnel (In this example, WAN0).
❸
Connection Name: Set a name for this tunnel such as IPSec_1.
❹
Remote Gateway (Domain Name): Enter an IP address of the enabled WAN port of the IPSec tunnel of the
remote router (In this example, 210.76.200.101).
❺
Local LAN/Mask: Enter a local LAN/subnet mask (In this example, 192.168.0.0/24).
❻
Remote LAN/Mask: Enter a remote router LAN/subnet mask (In this example, 192.168.0.0/24).
❼
Pre-shared key: Enter a pre-shared key (In this example, 12345678).
❽
Click OK.
After settings are successfully finished, the page is shown in the figure below.
Step 2: Set Router 2.
Click
.
- 69 -