Lan Setup - Tenda G3 User Manual

Device Management
Tip
Please use a correct MAC address to perform the clone action! A correct MAC address is a MAC address of a
computer on which a technician performs commissioning to surf the Internet during broadband installation.
Parameter description in the page:
Parameter Description
WAN Speed Router WAN port speed. The default is Auto. Do not change it unless necessary.
Maximum transmission unit. It is the maximum packet transmitted in the network device. It
MTU
is recommended to maintain the default setting.
MAC address of the WAN port. If the router cannot be connected to the Internet after
perform "Internet Setup", the reason may be that the broadband operator binds Internet
access information to a MAC address. At this point, perform MAC address clone and try to
surf the Internet.

Current MAC: Current MAC address of the router's WAN port.
Mac Address

Default MAC: Set the MAC address of the router WAN port to the factory default.

Clone Local MAC: Clone the MAC address of the computer that logs in to the router to
the router's WAN port.

Manual Input：Manual enter a MAC address to be cloned to the router WAN port.

4.2.3 LAN Setup

This section describes how to set the IP address and DHCP server parameters of the router LAN port. Click
『Network』>『LAN Setup』 to go to the configuration page.
The LAN port IP address is a management IP address of the router.
The DHCP server can automatically assign Internet access information such as IP address, subnet mask, gateway,
and DNS to clients that are successfully connected to the router. If this function is turned off, you can surf the
Internet only by manually configuring IP address information on the client. Keep the DHCP server enabled in the
absence of exceptional circumstances.
- 23 -