Installation; Receiving, Unpacking, And Removing The Dce Rack From The Pallet; Loading Equipment; Operating Door Handle - Vertiv DCE E42611 User Manual

3 INSTALLATION

3.1 Receiving, Unpacking, and Removing the DCE Rack from the Pallet
Inspect and report any damage before receiving. Unpack the rack by carefully removing the corrugated
carton and corners. Avoid damaging the rack when removing packaging.
WARNING: Only trained service personnel should be used to remove the rack from the pallet. Also, be
sure you have a sufficient number of service personnel. Do not attempt to move racks by yourself.
WARNING: Be careful when moving racks before installation. Sudden stops and starts, excessive
force, obstructed routes, and uneven floor surfaces may cause the rack to topple over.

3.2 Loading Equipment

WARNING: Only install equipment after the DCE Rack has been properly secured. Do not move the rack
assembly while loaded.
Once in place at the desired/intended location, deploy the leveling feet for maximum stability.
Rated or maximum-load capacity for the DCE Rack is 3000 pounds on the floor or on leveling glides.
To maintain a uniform distribution of the mechanical load in the DCE Rack, load the heaviest equipment
first, at the bottom of the DCE Rack and load the lighter units at the top.

3.3 Operating Door Handle

The door swing handles have been installed at the manufacturer. No additional assembly is required. To
operate the swing handle, lift up at the bottom of the handle then swing the handle to the right to open.
The handle must be kept in this position to close the door. Return the handle to the initial position and
use the key provided to lock the handle. The lock on the side panels will accept the same key.
The swing handles and doors are reversible. See "Reversing the door handle" below.

3.4 Reversing the door handle

1. Remove the Phillips-head bolt from the swing-handle retainer on the inside of the door.
2. Tilt the handle outward and lift up to remove it from the door.
3. Remove the Phillips-head cam retaining bolt, rotate the cam 180° and re-install cam retaining
bolt.
Vertiv | DCE Installer/User Guide | 9