Side Panel Removal; Top Panel Mounting - Vertiv DCE E42611 User Manual

3.7 Side Panel Removal

NOTE: Before removing doors, grounding wires must be disconnected.
The side panels are secured to the rack frame with a keyed lock.
To remove the side panel:
Unlock the panel, tilt the top of the side panel out slightly and lift the side panel up a couple of inches until
it is free as shown in the figure.
To install the side panel:
Reverse the process and lock the panel. Make sure the slots on the side panel engage with the two tabs at
the bottom of the frame.

3.8 Top Panel Mounting

The top panel of the rack is installed at the manufacturer.
To remove the top panel:
1. Remove the 6, M4 torx screws with a T15 screwdriver.
2. Lift the top panel out or off.
There are 3 top panel options for DCE Racks.
Figure 3.4 Removing the top panel and top-panel options
ITEM DESCRIPTION
1 Edge grommet on cut-outs
2 M4 Torx screw
Vertiv | DCE Installer/User Guide | 13