Table of Contents
Advertisement
3.9 Top Panel Mounting for the E426112DR
The top panel of the rack is installed at the manufacturer.
To remove the top panel:
1.
Before removing the top panel, you must remove the trough in the top half of the cabinet:
•
Open or remove the back door of the cabinet to access the trough.
•
Remove the acorn nuts, washers, and carriage bolts from the bottom of the trough.
•
Pull the bottom of the trough toward the center of the cabinet to disengage the flange at
the top of the trough from the top panel.
2. On the top panel, remove the 6, M6 flat-head Torx screws, and lift the top panel out or off.
To install the top panel:
1.
Insert the top panel and fasten with 6, M6 FH Torx screws.
2. Reinstall the cable trough by inserting the flange in the top panel and securing the bottom
with the carriage bolts, washers, and acorn nuts.
Figure 3.5 Removing the top panel of the E426112DR
ITEM
DESCRIPTION
1
Carriage bolt (2 per trough)
2
Trough
3
Washer (2 per trough
4
Acorn nut (2 per trough)
5
Trough flange
6
M6 Flat-head Torx screws (6 per top)
7
Top cover
8
Front of rack
9
Trough in top compartment (side panels not shown for clarity)
Vertiv | DCE Installer/User Guide |
14
Advertisement
Table of Contents
