Table of Contents
Advertisement
3.10 Bottom Panel Mounting for the E426112DR
The bottom panel of the rack is installed at the manufacturer.
To remove the bottom panel:
1.
Before removing the bottom panel, you must remove the trough in the bottom half of the
cabinet:
•
Open or remove the back door of the cabinet to access the trough.
•
Remove the acorn nuts, washers, and carriage bolts from the top of the trough.
•
Pull the top of the trough toward the center of the cabinet to disengage the flange at the
bottom of the trough from the bottom panel.
2. On the bottom panel, remove the 3, Flat-head screws that join the two halves of the panel.
3. Remove the 4 plastic covers to access and remove the 4 M8 Hex-head bolts that secure the
bottom panel.
CAUTION: Risk of sharp edges. The edges of the cutouts are sharp. Be careful when removing the
fasteners.
4. At the front of the rack, starting with the left panel, lift the center of the panel up and pull the
panel out, then repeat for the right panel.
To install the bottom panel:
1.
Insert right half, then the left half of the bottom panel, and secure with the 4 M8 Hex-head
bolts.
2. Install the plastic covers on the 4 holes, and the 3, Flat-head screws to join the two halves of the
panel
3. Reinstall the cable trough by inserting the flange in the bottom panel and securing the top
with the carriage bolts, washers, and acorn nuts.
Figure 3.6 Removing the bottom panel of the E426112DR
ITEM
DESCRIPTION
1
Flat washer (2 per trough)
2
Acorn nut (2 per trough)
3
Carriage bolt (2 per trough)_
4
Left-side half of bottom cover
5
M8 Hex-head bolt (2 per half of bottom cover)
Vertiv | DCE Installer/User Guide |
15
Advertisement
Table of Contents
