Table of Contents
Advertisement
4.2 Horizontal Front-to-rear Cable Manager: E11015/E12015
The front-to-rear horizontal cable manager for 800 W units allows cabling to be managed from front to
back of the DCE rack. The horizontal manager accepts lobster claw managers (part # 002185050), Velcro
Strap Managers (part # 002185060), and has slots to accept cable ties.
The managers come in two depths for 1100-mm and 1200-mm racks.
The cable manager can be installed into the frame in 4 places, 2 in the middle and 2 in the bottom.
Refer to the figure to fasten the frame in the chosen location.
Figure 4.2 Installing horizontal, front-to-rear cable manager
ITEM
DESCRIPTION
1
M6 Hex-head bolt
2
Hex nut
3
Mounting rail
4
Lacing bar
4.3 Front-to-rear Cable Trough: E811015/E812015
The 800-mm wide racks with depths of 1100 mm and 1200 mm have the option for front-to-rear cable
troughs. The troughs are adjustable with the movement of the mounting rails.
•
E811015: Adjustable from 20.188 in. to 33.464 in.
•
E812015: Adjustable from 22.188 in. to 38.464 in.
To install the cable trough:
1.
Measure front-to-back distance between EIA rails from inside to inside mounting planes.
2. Loosen or remove (2) center screws to allow for adjustment and movement of inner and outer
members.
3. Proceed to install trough into rack by finding the cut outs with (2) holes directly below cut-out.
4. From inside of rack and between rails, lift trough and engage tab through cut-out and drop
into place
Vertiv | DCE Installer/User Guide |
25
Advertisement
Table of Contents
