Table of Contents
Advertisement
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
o
About AlarmNet-i
o
About the 7810iR
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
About AlarmNet-i
AlarmNet-i is a fully encrypted secure method of delivering alarm messages from a protected
premise to an AlarmNet-i equipped central station. In a typical system, a 7845i Internet
Communication Module or Internet enabled user interface such as the 8132 Advanced User
Interface, routes status, supervisory, and alarm messages to the AlarmNet Control Center
using a broadband, internet connection. The AlarmNet Control Center identifies, validates
and forwards the messages to the appropriate 7810iR Central Station Receiver. AlarmNet-i
is implemented using TCP Internet protocol and 1024-bit encryption.
About the 7810iR
The 7810iR is the central station end of the AlarmNet-i reporting system. Using a
broadband Ethernet connection, the 7810iR receives Contact ID and ADEMCO high-speed
messages from the protected premises, locally displays them and simultaneously routes the
message to a LRR line card or directly to central station automation equipment.
7810iR Features
•
Automatic rollover to backup CS in the event of automation equipment failure.
•
Touch screen Graphical User Interface (GUI) for ease of use
•
Supports ADEMCO high-speed and ADEMCO Contact ID message formats
•
BlowFish 1024-bit message encryption
•
Buffers up to 100 messages
•
Selectable supervision period
•
Securely view and control from desk top via a secure web site remote access feature.
U L
The Remote Access feature has not been evaluated by UL.
•
Three automation modes for received messages:
1. Manual Mode: Stand-alone operation, received messages are displayed on the
U L
Manual Mode and Fail to Manual Mode cannot be used with UL installations.
2. LRR Line Card Mode: The 7810iR uses a serial interface to send received alarm
3. 685 Automation Mode: The 7810iR emulates the 685 digital receiver output
7810iR screen with an audible alert.
messages to an ADEMCO digital alarm receiver through a long-range radio line card.
protocol by using a direct serial interface to send incoming alarm messages to
automation equipment.
General Information
o
7810iR Features
S E C T I O N
1
1-1
Advertisement
Table of Contents
