Download  Print this page

Section 6 Message Formats; Message Formats; Ademco Contact Id Format; How Contact Id Is Displayed On 7810Ir - Honeywell AlarmNet 7810iR Installation And Setup Gude

Internet communication module
Hide thumbs

Advertisement

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
o

Message Formats

o

ADEMCO Contact ID Format

o
ADEMCO High-Speed Format
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Message Formats
There are two categories of messages that are sent by AlarmNet to the Central Station.
Subscriber Messages – indicate alarm or trouble conditions at the subscriber premises,
or identify issues with the subscriber radio, the 7845i Graphical User Interface, that is
enabled for Internet reporting or that may need attention. Subscriber messages can be
sent in one of two formats; ADEMCO high-speed or Contact ID
Network Messages – indicate specific conditions with the AlarmNet network, central
station transceivers, and or subscribers. Network messages are sent in ADEMCO high-
speed ONLY and may include messages for subscribers # 0000 or # 0001
ADEMCO Contact ID Format
Consists of:
A 4-digit subscriber ID
A 'qualifier' that indicates whether the message is an event or a restoral
An event code indicating the type of AlarmNet
An optional partition number
The exact zone or user number that initiated the report

How Contact ID is Displayed on 7810iR

SUBSCRIBER TYPE
= AlarmNet
A = AlarmNetA
C = AlarmNetC
M = AlarmNetM
S = System
I 23:52:00 07/11/02
TIME
DATE
RX LINE NUMBER
SUBS ID
CID IDENTIFIER
Always "18" Identifies the
message as a Contact ID format.
Does NOT display on the receiver.
EVENT QUALIFIER
An "E" for Event,
or an "R" for Restore.
Message Formats
14
1234 18 E 130 00 C 001
EVENT CODE
PARTITION #
C = CONTACT
U = USER
ZONE OR USER#
S E C T I O N
7810iR-004-V0
6-1
6

Advertisement

Table of Contents
loading

  Related Manuals for Honeywell AlarmNet 7810iR