Honeywell AlarmNet 7810iR Installation And Setup Gude page 61

Section 7: Diagnostics and Troubleshooting
Action Screen Display
3. Press the center of the square. The Touch
Screen Calibration screen displays Next
press the center of the box in lower right
corner.
4. Press the center of the square. The Touch
Screen Calibration screen displays Next
press the center of the box in lower left
corner.
5. Press the center of the square. The Touch
Screen Calibration screen displays Touch
target to verify calibration.
6. Press the center of the square. If touch
screen calibration was successful, you are
returned automatically to the
"Diagnostics/Tests" screen.
If touch screen calibration was not successful,
Calibration Unsuccessful is displayed
momentarily. You are then returned
automatically to the first Touch Screen
Calibration screen.
NOTE: You will progress through the Touch
Screen Calibration screens regardless of
where you touch. To successfully calibrate the
touch screen, you must press the center of the
box on each screen.
7-9