7810iR Internet Communication Module Installation and Setup Guide
2. Press the DIAGNOSTICS button on the
Advanced Setup Screen. The
"Diagnostics/Test" screen is displayed.
NOTE: 7810iR Diagnostics cannot be run
using Remote Access feature and will not run
locally if a Remote Access session is active.
The following error message will be displayed
if any diagnostic test is started while a Remote
Access session is active:
Select any diagnostic test or calibration procedure from the Diagnostics/Tests screen by
pressing its associated Test or Calibrate button.
All or any individual test may be run when you access the Diagnostics/Tests screen; however,
each test must be performed one at a time.
At any time when a test is not being performed, you can press:
return to the previous screen, or
to return to your home page.
Once the Diagnostics/Tests screen is exited, subsequent entry to this screen displays all test
options as "Not Performed."
the back button icon at the upper-right corner of the Diagnostics/Tests screen to
the home button icon in the upper left-hand corner of the Diagnostics/Tests screen