Show Cam Commands - Avaya P333T User Manual

Receive-
Flowcontrol-
Admin
Receive-
Flowcontrol-
Oper

Show cam Commands

Use the show cam commands to display the CAM table entries for a specific port
or MAC Address.
The syntax for this command is:
show cam [<mod_num>[/<port_num>]]
and
show cam mac <mac_addr>
Example:
Cajun_P330-N> show cam 1/1
Dest MAC/Route Dest Destination Ports
------------------- -----------------
00-40-0d-59-03-78
00-d0-79-0a-0a-da
00-40-0d-43-1e-e9
etc...
Cajun_P330-N> show cam mac 00-40-0d-88-06-c8
Dest MAC/Route Dest Destination Ports
------------------- -----------------
00-40-0d-88-06-c8
Total Matching CAM Entries Displayed = 1
Avaya P333T User's Guide
Receive flow-control administration. Possible settings:
• ON indicates that the local port will act upon flow control
indications if received from the far end.
• OFF indicates that the local port will discard flow control
frames if received from the far end.
Receive flow-control operation mode. Possible modes:
• ON indicates that the local port will act upon flow control
indications received from the far end.
• OFF indicates that the local port will discard flow control
frames received from the far end.
1/1
1/1
1/1
1/1
Chapter 6 Cajun Campus CLI – Layer 2
55