Command Line Prompt; Avaya P330 Sessions - Avaya P333T User Manual

If the IP address in the Telnet command is of the router, connection is
established to the Router CLI entity in the router module.
5 When you see the "Welcome to P330" menu and are prompted for a Login
Name, enter the default name root
6 When you are prompted for a password, enter the User Level password root
or norm in lower case letters (do NOT use uppercase letters). The User level
prompt will appear when you have established communications with the
Avaya P330.Enter the Cajun P330 Privileged level by typing enable
7 You can now configure the Cajun P330 stack and change its default IP address.

Command Line Prompt

When you start the CLI, the initial prompt shows the number of the Master module
in the Avaya P330 stack. For example, if the stack Master is Module 5, counting from
the bottom up, then the prompt is:
Cajun_P330-5>
In this document the Module number in the prompt is generic and is represented by
"N".
If you wish to open a session with a Avaya P333R-LB routing module in the stack
or reopen a session with the Master module, use the session command (see
below).
The command prompt is not hierarchical in structure. If you wish to use several
commands, each beginning with the same keyword, you must retype all parts of
the command each time. For example, if after you want to set the system contact
and the system name you must type both set system contact and set
system name. However, you can use command abbreviations – see page .

Avaya P330 Sessions

You can use sessions to switch between P330 modules or to switch between Layer 2
and Layer 3 commands in the P333R CLI.
To switch between P330 modules use the command:
session [<mod_num>] <mode>.
The <mod_num> is the number of the module in the stack, counting from the bottom
up. The <mode> can be either switch or router. When Module Number is not
specified, the command switches between the modes in the local module. Use
switch mode to configure layer 2 commands. Use router mode to configure routing
commands.
Examples:
To configure router parameters in the module that you are currently logged into,
type the following command:
session router.
Avaya P333T User's Guide
Chapter 5 Cajun Campus CLI - Architecture, Access & Conventions
33