Set Port Redundancy On/Off Command; Set Port Redundancy Commands - Avaya P333T User Manual

Set port redundancy on/off Command

Use the set port redundancy command to define/remove redundancy
schemes between a Primary and a Secondary link. The link can be any port that does
not belong to a LAG, or a LAG interface. In either case, there should not be any
redundancy scheme already defined on any of the links.
The syntax for this command is:
set port redundancy <mod_num>/<prim_port_num> <mod_num>/
<second_port_num> {on/off} [<redundancy_name>]
prim_port_num
second_port_num
redundancy_name
Example:
Cajun_P330-N# set port redundancy 1/7 2/12 on red1
uplink: Port 2/12 is redundant to port 1/7.
Port redundancy is active - entry is effective immediately

Set port redundancy Commands

Use the set port redundancy commands to enable or disable the defined
redundancy schemes. Using this command will not delete existing redundancy
entries.
Note: You must disable Spanning Tree before you can enable redundancy.
The syntax for this command is:
set port redundancy {enable|disable}
Example:
Cajun_P330-N# set port redundancy enable
All redundancy schemes are now enabled
Avaya P333T User's Guide
Chapter 6
Primary link of the redundancy scheme
Secondary link of the redundancy scheme
Name for the redundancy scheme (optional)
Cajun Campus CLI – Layer 2
91