Chapter 6
Cajun Campus CLI – Layer 2
Set ppp Commands
Set ppp authentication Command
Use the set ppp authentication command to define the authentication
method used for a PPP server or client session.
The syntax for this command is:
set ppp authentication incoming {pap|chap|none}
incoming
pap
chap
none
Example:
Cajun_P330-N(super)# set ppp authentication incoming chap
Set ppp incoming timeout Command
Use the set ppp incoming timeout command to configure the number of
minutes until the system automatically disconnects an idle PPP incoming session.
The syntax for this command is:
set ppp incoming timeout <timeout>
timeout
Example:
Cajun_P330-N> set ppp incoming timeout 15
PPP incoming session will automatically disconnect after 15
minutes of idle time
Set ppp baud-rate Command
Use the set ppp baud-rate command to define the baud rate used in PPP sessions.
Note that the peer baud rate must be set at the same value as the host.
The syntax for this command is:
set ppp baud-rate <9600 | 19200 | 38400>
100
incoming authentication use for PPP dial-in
sessions
PAP authentication method
CHAP authentication method
No authentication
The timeout in minutes.
Avaya P333T User's Guide