Teledyne G3-GM10-M0641 User Manual page 96

Exposure Mode
Timed
Trigger Width
Exposure Alignment
Synchronous
Reset
Exposure Delay
Exposure Time
Actual Exposure Time
Sensor Shutter Mode
Global
Global Reset
Rolling
Gain Selector
Sensor
Sensor Analog
Sensor Digital
Digital
Gain
Gain (Raw)
•
94 Operational Reference
ExposureMode
Timed
TriggerWidth
exposureAlignment
Synchronous
Reset
exposureDelay
ExposureTime
exposureTimeActual
SensorShutterMode
Global
GlobalReset
Rolling
GainSelector
SensorAll
SensorAnalog
SensorDigital
DigitalAll
Gain
GainRaw
Sets the operation mode for the camera's exposure (or electronic shutter).
< Beginner >
The exposure duration time is set using the Exposure Time feature and the exposure starts with a
FrameStart event.
Uses the width of the trigger signal pulse to control the exposure duration. Use the Trigger
Activation feature to set the polarity of the trigger.
The Trigger Width setting is applicable with Trigger Selector = Single Frame Trigger(Start).
Exposure Alignment specifies how the exposure is executed in relationship to the sensor capabilities
and current frame trigger.
< DFNC Beginner >
Exposure is synchronous to the internal timing of the sensor. The readout is concurrent to the
exposure for the fastest possible frame rate. When a valid trigger is received and the ExposureTime
is shorter than the readout period, the ExposureStart event is latched in the previous frame's
readout. That is; the ExposureStartEvent is delayed and is initiated when the actual exposure starts
such that the exposure ends and readout begins as soon as the previous readout has completed.
Sensor timing is reset to initiate exposure when a valid trigger is received. Readout is sequential to
exposure, reducing the maximum achievable frame rates. That is, a trigger received during
exposure or readout is ignored since data would be lost by performing a reset.
Specifies the delay in microseconds (µs) to apply after the FrameStart event before starting the
ExposureStart event.
< DFNC Beginner >
Sets the exposure time (in microseconds) when the Exposure Mode feature is set to Timed.
< Beginner >
Actual Exposure Time performed by sensor due to its design, based on the requested Exposure
Time.
< Beginner >
States or selects the supported shutter mode of the device.
< Beginner >
The shutter exposes all pixels at the same time.
The shutter opens at the same time for all pixels but ends in a line sequential manner.
The shutter opens and closes sequentially for groups (typically lines) of pixels.
Selects which gain is controlled when adjusting gain features.
< Beginner >
Apply a gain adjustment within the sensor to the entire image. The first half of the gain range is
applied in the analog domain and the second half is digital.
Apply an analog gain adjustment within the sensor to the entire image.
Apply a digital gain adjustment within the sensor to the entire image.
Apply a digital gain adjustment to the entire image. This independent gain factor is applied to the
image after the sensor.
Sets the selected gain as an amplification factor applied to the image. User adjusts the Gain feature
or the GainRaw feature.
< Beginner >
Raw Gain value that is set in camera (Model Specific for range and step values).
< Guru>
Ver. 1.06
ver. 1-02
ver. 1.02
Nano Series GigE Vision Camera