Teledyne G3-GM10-M0641 User Manual page 117

TriggerOverlap=EndOfExposure
•
• Trigger is accepted immediately after the previous exposure period. This will latch the Trigger
and delay the Exposure if the end of that exposure is shorter than the previous readout.
Diagram Conditions:
TriggerMode=On
•
ExposureMode=Timed
•
TriggerActivation=RisingEdge
•
TriggerDelay=0
•
TriggerSelector=FrameStart
•
ExposureAlignment=Synchronous
•
Applicable to current Sony sensor models
Sony sensor Nano models support a maximum trigger rate by allowing a trigger signal soon after
the exposure period. A trigger is accepted and buffered for a 12 line clock period (after the
exclusion period) at which the next exposure starts. As shown in the diagram below, the following
exposure can be active even before the frame readout of the previous exposure.
TriggerOverlap=EndOfExposure
Trigger Input
Frame Exposure
Frame Readout
Refer to Model Part Numbers
specifications.
Nano Series GigE Vision Camera
Trigger Exclusion Period
Exposure 1
Frame 1 Active period
for the available Nano models using Sony sensors and their timing
Trigger Exclusion Period
Exposure 2
Readout 1
Frame 2 Active period
Operational Reference
Readout 2
•
115