Teledyne G3-GM10-M0641 User Manual page 91

Device Temperature DeviceTemperature
DALSA Software DALSASoftwareCompatibilityComponentList
Compatibility
Component List
TurboDrive 8-bit
requires v8.01
or greater
TurboDrive 10-bit
requires v8.10 or
greater
TurboDrive 12-bit
requires v8.10 or
greater
Multicast requires a
newer version
Power-up Configuration UserSetDefaultSelector
Selector
Factory Setting
UserSet1
UserSet2
User Set Selector UserSetSelector
Factory Setting
UserSet 1
UserSet 2
Load Configuration UserSetLoad
Save Configuration UserSetSave
Power-up Configuration UserSetDefault
Selector
Serial Number DeviceID
Factory Setting Default
UserSet1
UserSet2
Nano Series GigE Vision Camera
The temperature of the selected source in
degrees Celsius. Maximum temperature
should not exceed +70°C for reliable
operation.
List the optional Teledyne DALSA software
functions that are supported.
Compatibility1 Teledyne DALSA Turbo Drive 8-bit
(Monochrome or Bayer) requires Sapera-LT
8.01 or greater.
Compatibility2 Teledyne DALSA Turbo Drive 10-bit
(Monochrome or Bayer) requires Sapera-LT
8.10 or greater.
Compatibility3 Teledyne DALSA Turbo Drive 12-bit
(Monochrome or Bayer) requires Sapera-LT
8.10 or greater.
Compatibility4 Multicast feature support requires a newer
version of Sapera LT than currently installed.
Selects the camera configuration set to load
and make active on camera power-up or
reset. The camera configuration sets are
stored in camera non-volatile memory. (RW)
Default Load factory default feature settings.
UserSet1 Select the user defined configuration UserSet
1 as the Power-up Configuration.
UserSet2 Select the user defined configuration UserSet
2 as the Power-up Configuration.
Selects the camera configuration set to load
feature settings from or save current feature
settings to. The Factory set contains default
camera feature settings. (RW)
Default Select the default camera feature settings
saved by the factory.
UserSet1 Select the User Defined Configuration space
UserSet1 to save to or load from features
settings previously saved by the user.
UserSet2 Select the User Defined Configuration space
UserSet1 to save to or load from features
settings previously saved by the user.
Loads the camera configuration set specified
by the User Set Selector feature, to the
camera and makes it active. Can not be
updated during a Sapera transfer. (W)
Saves the current camera configuration to the
user set specified by the User Set Selector
feature. The user sets are located on the
camera in non-volatile memory. (W)
Specify the camera configuration set to load
and make active on camera power-up or
reset. The camera configuration sets are
stored in camera non-volatile memory.
Displays the device's factory set camera serial
number.
Select the Factory Setting values as the
Power-up Configuration.
UserSet1 Select the user defined configuration UserSet
1 as the Power-up Configuration.
UserSet2 Select the user defined configuration UserSet
2 as the Power-up Configuration.
Beginner
Beginner
Beginner
Beginner
Beginner
Beginner
Beginner
Operational Reference
1.00
1.00
1.00
1.00
1.00
1.00
1.00
1.00
Invisible
1.00
Invisible
•
89