Edit Menu Parameters; Channel/Program; Setup - Kawai MP7SE Owner's Manual

EDIT Menu parameters

1

Channel/Program

1. MIDI Transmitting Channel
This parameter determines which MIDI channel will be used to
transmit event information for the selected zone.
* By default, SUB2 and SUB3 zones are assigned MIDI channels 01 and 02.
MAIN and SUB1 zones are assigned MIDI channels 03 and 04.
* The specified MIDI transmit channel should match the MIDI Receive
channel of the connected MIDI device.
3/4. Bank MSB/Bank LSB
This parameter determines which MSB and LSB number will
be transmitted when a SETUP is recalled. The MIDI standard
allocates 128 storage spaces, however this number can be
expanded using an MSB and an LSB.
The diagram to the right illustrates how the Program Number,
MSB Bank, and LSB Bank are organised.
* Please refer to the owner's manual of the connected MIDI device for
further information.
2

SETUP

1. Send Program
This parameter determines whether or not a Program Change
Number will be transmitted when a SETUP is recalled.
To change sounds on external MIDI devices when recalling a SETUP, set
this parameter to ON.
3. Send Volume
This parameter determines whether or not an initial MIDI
Volume message will be transmitted when a SETUP is recalled.
* Adjusting the volume of a zone by turning the control knobs will still
transmit values even if this parameter is set to OFF.
 SETUP parameters in the SYSTEM menu
The above Send parameters can be overridden by the SETUP
Program, SETUP Bank, SETUP Volume, SETUP Knobs parameters
in the MIDI category of the SYSTEM menu (page 110).
When these SETUP parameters are set to OFF, an asterisk will be
shown beside the relevant Send parameter to indicate that the
EDIT menu setting is being overridden.
56
(EXT mode)
2. Program
: 01 ~ 16
value cH cH
This parameter determines which Program Change Number
will be transmitted when a SETUP is recalled. For example,
the desired Program number of a sound on the external MIDI
device.
: 0 ~ 127
value
2. Send Bank
o , o
n ff
This parameter determines whether or not Program Bank
Numbers (MSB, LSB) will be transmitted when a SETUP is
recalled.
If the external MIDI device requires a Bank Select message, set this
parameter to ON.
4. Send Knobs
o , o
n ff
This parameter determines whether or not control knob
settings will be transmitted (ON) or not (OFF) when a SETUP
is recalled.
* Turning the control knobs will still transmit values even if this parameter
is set to OFF.
Asterisk:
Parameter is
overridden by
SETUP menu
: 1 ~ 128
value
o , o
n ff
o , o
n ff