Table of Contents
Advertisement
6.1 Editing Procedure and Parameters
6.2 Edit Parameters
Zone No.
Zone No.
Sound Name
Sound Name
1
1
Classic EP
Classic EP
Vel Comp.
Vel Comp.
= 10
= 10
Parameter
Parameter
Value
Value
6.2.1 Zone Mode
1
1
Concert Grand
Concert Grand
SZone Mode =Both
SZone Mode =Both
6.2.2 Sound (Int only)
1Internal Sound
1Internal Sound
= Concert Grand
= Concert Grand
First, press the ZONE SELECT button for the zone to be edited.
Next, press the MENU buttons until the parameter you want to edit appears in
the DISPLAY. When a zone is set as Both, pressing the ZONE SELECT button again
will switch the menu list from Internal to External or vice versa.
Set the value of the parameter using the VALUE buttons.
Since each parameter has a di erent value range, consult the following pages
for the details. Repeat this procedure for any other parameters in any of the
zones that need to be modi ed.
Save these settings using the STORE button.
(See page 53 for detail)
Note:
Once you enter the edit mode from SETUP mode by pressing the MENU button,
the mode automatically changes to SOUND mode and the SOUND SELECT buttons
are used to select sounds, not SETUPs.
You can exit the edit mode by pressing the EXIT(SW) button. Any edits you have
made so far will be retained to SOUND mode. If you exit the edit mode by pressing
SOUND or SETUP buttons, your changes will be lost and the previously saved
settings are recalled.
Zone parameters can be edited individually for each zone. There are two
parameter groups, Internal parameter group and External parameter group. If
a zone is set to Int, only Internal parameters are available for editing. If a zone is
set to Ext, only External parameters are available for editing. If a zone is set to
Both, both Internal and External parameters are available for editing.
This parameter sets the Zone mode. The example shows that the Zone 1 is set
to Both mode.
This parameter determines which internal sound is assigned for the selected
zone.
35
Advertisement
Table of Contents
