Kawai MP7SE Owner's Manual page 121

Pedal, Controller
Pedals or wheels don't work.
The Modulation Depth Range
parameter has no effect.
The foot switch pedal does not
work and a malfunction occurs in
the MP7SE.
The foot switch does not turn off
after releasing the pedal.
The expression pedal does not work
and a malfunction occurs with the
MP7SE.
The top 18 notes of the
keyboard sustain for longer than
neighbouring notes, even when the
damper pedal is not pressed.
The sound continues to sustain
after the damper pedal is released
and re-pressed.
Line In
The volume of the device
connected to the Line In jacks is too
low/too high (distorted).
The adjustable range of the LINE IN
fader is too narrow.
MIDI
The MP7SE's Song Recorder
(Internal Memory) cannot record
the MIDI section.
MMC cannot control the external
device.
Check that the controller is not set to Off in the EDIT:Controllers menu.
Check that the included F-10H damer pedal is not connected to the 'FSW' or
'EXP' jack. Please connect the included F-10H damper pedal to the correct
'DAMPER (F-10H)' jack.
Check that the modulation wheel function is set to 'Modulation' in the EDIT
menu. If not, the Modulation Depth Range parameter will have no effect.
Check that the foot switch pedal is not connected to the 'DAMPER (F-10H)' or
'EXP' jack. Please connect the foot switch pedal to the 'FSW' jack.
Check that the foot switch pedal is a 'Normal Closed' polarity type. If using
a 'Normal Open' polarity type, please set the FSW Polarity setting in the
SYSTEM:Pedal/Mod. menu to Reverse.
Please check that the expression pedal's TRS connector type is set correctly,
using the EXP TYPE switch on the rear jack pack.
This is the correct behaviour, and intended to reproduce the undamped notes
(typically the top two octaves) of an acoustic grand piano.
This is the correct behaviour, and reproduces the ability to sustain notes when
quickly re-pressing the damper pedal of an acoustic grand piano.
Check the position of the LINE IN fader, and adjust as necessary.
Adjust the Input Level in the SYSTEM:Utility menu.
Check that the TransmitRecorder parameter in the EDIT:Transit menu is set to
On. By default, this parameter is set to Off.
Check that the Transmit MMC parameter in the EDIT:MMC menu is set to On. By
default, this parameter is set to Off.
Check that the MMC device ID is set correctly, and matches the external device's
ID. If thedigignate is not necessary, please set to 127 (default, All).
Check the external device's owner's manual to ensure that MMC messages are
recognised.
Check that the external device's MIDI clock is not set to External. The MP7SE
does not send MTC (MIDI Time Code) or MIDI Clock data, therefore the external
device should be set to use its own internal clock.
Page
49
60
18
49
18
108
17
Page
12
107
Page
57
57
57
121