Kawai MP7SE Owner's Manual page 43

 About DCA Parameters
The DCA (Digitally Controlled Amplifier) parameters, are used to
adjust the volume level of a sound over time using an envelope.
The diagram below indicates the MP7SE's DCA parameters.
6
5
Key ON
16. Vibrate Depth
This parameter adjusts the depth of the vibration applied to the
selected sound.
18. Vibrate Delay
This parameter adjusts the delay time before the start of the
vibration.
19. Octave Layer Switch
This parameter turns the additional Octave Layer ON or OFF.
21. Octave Layer Range
This parameter sets the amount of octave transposition for the
Octave Layer.
23. Portamento
This parameter turns portamento playing ON or OFF.
Portamento describes the effect of pitch sliding from one note to another.
25. Portamento Mode
This parameter changes the portamento mode.
Portamento Mode Description
Rate The time required for the portamento will be variable. The distance between notes will affect the portamento time.
Equal The time required for the portamento will be constant. The distance between notes will not affect the portamento time.
8
7
Key OFF Time
: –64 ~ +63
value
: –64 ~ +63
value
o , o
ff n
: –2 ~ +2
value
o , o
ff n
 About DCF Parameters
The DCF (Digitally Controlled Filter) parameters, are used to
adjust a low-pass filter applied to the sound over time.
The diagram below indicates the MP7SE's DCF parameters.
11
9
10
Key ON
17. Vibrate Rate
This parameter adjusts the speed of the vibration applied to the
selected sound.
20. Octave Layer Level
This parameter adjusts the volume level of the Octave Layer.
22. Octave Layer Detune
This parameter adjusts the tuning of the Octave Layer.
24. Portamento Time
This parameter adjusts the time required for the portamento
(i.e. the speed of the 'slide' between notes).
13
12
Key OFF Time
: –64 ~ +63
value
: 0 ~ 127
value
: –64 ~ +63
value
: 0 ~ 127
value
r , e
ate qual
43