Troubleshooting; Ping Ipv4 - NETGEAR XS708T User Manual

XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
The following table describes the information available on the page.
Table 94. Dual Image Status information
Field
Image1 Ver
Image2 Ver
Current-active
Next-active
Image1 Description
Image2 Description

Troubleshooting

You can use a ping or a traceroute, and you can perform a memory dump.
The Troubleshooting page contains links to the features described in the following sections:
•

Ping IPv4

on page 401
• Ping IPv6 on page 403
• Traceroute IPv4
• Traceroute IPv6
• Remote Diagnostics
• Configure Memory Dump Settings and Perform a Full Memory Dump
Ping IPv4
Use this page to tell the switch to send a ping request to a specified IP address. You can use
this to check whether the switch can communicate with a particular IP station. When you click
the Apply button, the switch sends a specified number of ping requests and the results are
displayed.
If a reply to the ping is not received, the following message displays:
Tx = Count, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec
If a reply to the ping is received, the following message displays:
Reply From a.b.c.d: icmp_seq = 0. time= xyz usec.
Reply From a.b.c.d: icmp_seq = 1. time= abc usec.
Reply From a.b.c.d: icmp_seq = 2. time= def usec.
Tx = count, Rx = count Min/Max/Avg RTT = xyz/abc/def msec
Description
The version of the image1 code file.
The version of the image2 code file.
The currently active image on this switch.
The image to be used on the next restart of this switch.
The description associated with the image1 code file.
The description associated with the image2 code file.
on page 404
on page 406
on page 408
Maintenance
401
on page 409