NETGEAR XS708T User Manual page 72

XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
The following table describes the nonconfigurable fields.
Table 22. Green Ethernet Statistics Summary information
Field
Current Power Consumption by all
ports in Chassis (mWatts)
Estimated Percentage Power
Saving per chassis (%)
Cumulative Energy Saving per
Chassis (Watts * Hours)
Unit
Green Features supported on this
unit
Interface
Energy Detect Admin mode
Energy Detect Operational Status
Short Reach Admin mode
Short Reach Operational Status
EEE Admin mode
Configure the Green Ethernet EEE LPI History
Use this page to configure and view the Green Ethernet low power idle (LPI) history.

To configure the port Green Ethernet EEE LPI history:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
Description
Estimated Power Consumption by all ports in chassis in mWatts.
Estimated percentage of power saved on all ports in chassis when
green modes are enabled.
Estimated cumulative energy saved per chassis in watts * hour when all
green modes are enabled.
The unit ID.
List of green features supported on the given unit, which could be one
or more of the following: Energy-Detect (Energy Detect), Short-Reach
(Short Reach), EEE (Energy Efficient Ethernet), LPI-History (EEE Low
Power Idle History), LLDP-Cap-Exchg (EEE LLDP Capability
Exchange), Pwr-Usg-Est (Power Usage Estimates).
Interface for which data is displayed or configured.
Enable or disable Energy Detect mode on the port. When this mode is
enabled, when the port link is down, the PHY automatically goes down
for a short period of time, then wakes up to check link pulses. This
allows the switch to perform autonegotiation and save power
consumption when no link partner is present.
Current operational status of the Energy Detect mode.
Enable or disable Short Reach Admin mode on the port. With Short
Reach mode enabled, PHY is forced to operate in low power mode
irrespective of the cable length.
Current operational status of the Short Reach mode.
Enable or disable Energy Efficient Ethernet mode on the port. With
EEE mode enabled, the port transitions to low power mode during link
idle conditions.
Configure System Information
72