NETGEAR XS708T User Manual page 208
8-port, 12-port, and 16-port
10-gigabit smart managed pro switch
Hide thumbs
Also See for XS708T:
- Hardware installation manual (32 pages) ,
- Installation manual (2 pages) ,
- Installation (2 pages)
Table of Contents
Advertisement
XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
14.
In the Adv NS Interval field, specify the retransmission time field of router advertisements
sent from the interface.
A value of 0 means the interval is not specified for the router. The range of the neighbor
solicit interval is 1000 to 4294967295. The default is 0.
15.
In the Adv Reachable Interval field, specify the router advertisement time.
This is the time allocated to consider the neighbors reachable after ND confirmation. The
range of reachable time is 0 to 3600000. The default is 0.
16.
Use the Adv Interval field to specify the maximum time allowed between sending router
advertisements from the interface.
The range of the maximum advertisement interval is 4 to 1800. The default value is 600.
17.
From the Adv Managed Config Flag menu, specify the setting for the router advertisement
managed address configuration flag.
When the selection is Enable, end nodes use DHCPv6. When the selection is Disable,
end nodes autoconfigure addresses. The default value is Disable.
18.
From the Adv Other Config Flag menu, select to enable or disable the router
advertisement other stateful configuration flag.
The default value is Disable.
19.
From the Router Preference menu, specify the router preference advertisement on an
interface.
The default value is Medium.
20.
From the Adv Suppress Flag menu, select to enable or disable the router advertisement
suppression on an interface.
The default value is Disable.
21.
From the Destination Unreachables menu, select to enable or disable the mode for
sending ICMPv6 destination unreachable messages on this interface.
If this mode is disabled, the interface does not send ICMPv6 destination unreachable
messages. By default, the IPv6 destination unreachables mode is enabled.
22.
Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The following table describes the nonconfigurable data that is displayed.
Table 57. IPv6 VLAN Configuration information
Field
Routing Mode
Description
Displays the routing mode of an interface. The default is Disable.
Configure Routing
208
Hide quick links:
Advertisement
Table of Contents
